March 30, 2020
Firmware 1.07
- Resolves an issue whereby playback did not start from the position it stopped.
- Fixed an issue that not all Worktypes were being displayed.
December 13, 2019
Firmware 1.06
- Improve speed for Rev/Que
- Display number of files. (Current file/ Total number of files)
- Change operation according to the position of the slide switch when recovered from sleep
- Improve startup time. (with & w/o SD card)
- Recover from Sleep with Motion Sensor during Dim setting
- Notify users that the battery level must be more than 50% during firmware update
- Fixed an issue whereby, under certain conditions, new files were being created during a single recording
September 19, 2019
Firmware 1.04
- Improved the device charging specifications.
- Enabled to charge via USB even when the device is PIN Locked.
- Support recharge from Battery Low via USB AC.
- Deleted the confirmation screen for “Charge battery?” when charging via USB AC.
- Fixed the issue that the SD card may not be visible as a drive when connected to a Mac.
- Fixed the issue that the speaker and microphone might not work when connected to a Windows 10.
- Fixed the issue that the REW does not function at file end.
- Changed the order of files to always be in the order of Job numbers.
- Support Append Recording in MP3 format. Insert recording and overwrite recording are not supported.
- Rev to Stop will no longer overrun the stop position.
- Support a skip to the beginning or end of the file when you double click REW or FF.
- Improved so that noise from the slide switch will be minimized when you Append Recording.
June 20, 2019
Firmware 1.03
- Fixed the issue that files may not playback properly due to a noise which might occur from the middle of the file.
April 2, 2019
Firmware 1.02
- Fixes an issue where a file may not play back correctly when recorded in VCVA mode.
August 1, 2018
Firmware 1.00
- Original Firmware